Detailed Installation & Adjustment Instructions

for Electrical Curtain System :

1. Curtain package

2. Make sure you received all parts in the checklist on the manual

3. Loosen big-head screw from the running track

4. Loosen small head screw from the middle track

5. Loosen end base screw

6. Pull out the end base

.

7.Slide in extension track with connector

8.Your joint extension should slide in horizontally

9.Decide the number of extension tracks required and slide back in end base. Track can be cut with
a hacksaw if a fractional fit is required.

10.Secure end base connection and tighten back screw

11. Pull both track cables left or right until cable is even

12. Your track cable should look like this. Note: when track cable is even, both running tracks will meet in the middle.

13. Pull track cables to maximum tightness and tighten big head screw. Then tighten small head screw previously unloosen.

Ensure track cables do not cross each other, they should be on correct separate direction paths.

14. Tighten bolt on the side of carrier base to a medium tension with the spanner provided

Note: avoid over tension from full tightening

15. Medium tension bolt tightness should look similar to this

16. Slide open red catch and insert gear box

17. Set red panel switch to "On" for number 1 curtain number or appropriate curtain for remote control referral

18. Plug in Power adapter

19. Perform a test run without any curtains attached. The track should automatically stop when fully open / close

Note: Tighten carrier bolt more if track does not do this, (refer to step 14.)

20. Install curtain as preferred with provided brackets & clips etc.

Return to Decorama Home Page